2010 ~ 2011 7 / 27 BY: 3DBBQ
TMG (The Mad Ghost) through the test of battle, not out, is everyone's favorite gun, the teaching of writing the article here.
JSPB-TMG X 3
1. 3Pumps fire 1 mega dart, total of six rounds
2. distance of about 20 meters
3. ARB mechanisms, high accuracy
4 small, one-handed shooting
5 easy made, low price of materials
7 three-point grip, stable shooting
tool & Material
2 pipe cutter
4 diagonal pliers
5 needle nose pliers
1 inch check valve
1 / 2 inch Check Valve
---- Link with PVC ----------
1 inch pipe
1 / 2 inch pipe
1 / 2 inch electric tube (thin tube)
3 / 4 inch electric tube (thin tube)
------ Original -------------
1 / 2 inch Tee x1
1 / 2 inch L x3
1X1 / 2 inch OS x1
1 inch l x2
PU High-pressure plastic hose (large)6.5*10
PU High-pressure plastic hose (small)5*8
Faucet seal skin
8cm wood screws
Fishing line (thin wiring)
1" Bike pump
First, the pump valve removed, increasing the air.
Install the check valve, which is directional, do not install the wrong side.
Prepare two L, take it together.
This is a tip, pipe a thin line above, it is the mold line, after the glue line can be used to align.
1 inch PVC pipe to put up, right, right to see, and mark
Then remove the PVC pipe, we need to be measured can only be installed 3 cm (measured results for each different brand)
Six centimeters of PVC cut this down now!
For the part of the check valve also requires cutting a section, let us use the marker tag.
Is about six centimeters.
cutting down ~
This special glue water stage when we first painted the right side, remember to ㄧ circle all painted to, if not applied uniformly, will lead to leakage, it is very serious.
We put a stick of glue squeezed side check valve.
The L stick up.
Good to just cut PVC pipe glue.
Sticky good side, the other side of the stick.
Focus here, this time loaded up when another L must be aligned, we quickly find the line, this will make to the gun straight.
We use a PVC pipe to align and adjust, put something, if there are crooked off the gun will be very easy to find, and very easy to adjust.
(Note that the kill time soon, want to take a hard fall before the adjustment is completed, if the force has been adjusted with the violence will lead to loss of adhesive glue,)
Again cut a PVC, the glue stick.
After installing 1X1 / 2 OS Barrel after you're done!
This post has been edited by 3DBBQ: 28 July 2011 - 05:01 PM