-3/16" wooden dowel rod
-A pen tube that will fit in the receiver
-Hot glue and glue gun
-5/16" drill bit
First off, grab your stampede clip. You can try to pry and make it clean as best you can, but I wasn't able to break the glue on some of the tabs.
Instead, go the easy route and dremel right through those tabs!
Undo these two screws.... and you're still not in.
Wait, before you throw it at a wall! All you have to do is pull the halves apart to break the glue that these rubber pieces use to hold onto the inside halves of the clip.
Now grab your 3/16 wooden dowel and mark and cut it at 10 and 1/4" long.
Grab your pen tube. This is the one I used, and it had a perfect snug fit in the receiver.
Cut a 1 and 1/8" section of the tube.
Drill a 5/16" hole through the receiver at the right distance for your darts. My pen tube required me to drill a 5/16 hole and then go around the hole once with scissors.
Insert your pen tube into the hole you drilled. I used no adhesives here, since I made mine fit perfectly.
Hot glue the dowel rod to the bottom of the clip. Use the receiver to line in up.
Get the receiver and spring back into the clip and screw the bottom half together. Since we cut the tabs earlier, we are going to have to glue the halves together.
Wrap your rubber band around the top to hold the halves together while you apply your super glue. Rub the super glue in so that it doesn't protrude in the mag well. Sit this upright, and when it is dry, enjoy having triple the shots before swapping out clips. Also, I use this method on my 6-shot clips too, and it works great and has never jammed on me.
This post has been edited by WicketTheModder619: 14 May 2011 - 03:06 PM