#1
Posted 26 December 2002 - 11:58 PM
My question is, has anyone else done this (honestly)? Most people said "Oh, CXWQ has most likely done this."
Anyway, my EAB is named Sven, and all it really needs a paint job.
but we do sh*t and F---"
~Webbster, Foam Improvement.
"I got four points... I sackled you"
#2
Posted 27 December 2002 - 12:36 PM
I did a 12" long 19/32" brass barrel that's slightly oversized for my darts. This works nicely with the fast/weak air delivery of the EaB and makes it easy to muzzle load the darts since they slide all the way down when I cock it. I also did a spring replacement so I don't need to band. I get about 80' level and 105' angled with micro stefans.
There's really no need to use a nested/telescoped brass barrel with the EaB since the air delivery characteristics are more like an air gun than a typical spring gun. That massively oversized plunger is the main reason it's my favorite gun.
#3
Posted 27 December 2002 - 12:50 PM
8-Bit Theater
Gravity Nerf
#4
Posted 27 December 2002 - 04:58 PM
#5
Posted 27 December 2002 - 06:36 PM
That is similar to the Sven 2 concept, where I planned to inegrate a 1500 underneath. I realized that it wouldn't fit. However, if you do an extrogration, it may work. Unfortunately, that broke my 1500 internals.Frenzy, that happened to mine too and I filled it up with tons of epoxy but it didn't hold. Duct tape was actually able to hold it for a couple days at a time but eventually I gave up on it. For any good modders out there, I think that there is enough room under the barrel to integrate an at2k. I need to run to TRU and buy one, then do some handy work with my hack saw.
but we do sh*t and F---"
~Webbster, Foam Improvement.
"I got four points... I sackled you"
#6
Posted 28 December 2002 - 06:06 PM
1 user(s) are reading this topic
0 members, 1 guests, 0 anonymous users