"We've got work to do"
-Forsaken_Angel24
Materials
- Foam Craft Board
- Construction Paper (White)
- Tape
- Hot glue
- 1/2 in PVC
Print out this template, and this template, before you print, click on full size, then copy and paste it to a word document. Trace them onto foam craft board, or lexan. NOTE: DO NOT resize these templates, if you printed them correctly, the strip should be 15in. long.
Cut them out with an exacto-knife and they should look like this.
Slide the Clip into the two groove's and apply hot glue.
The clip should now look like this.
Wedge a 2in Segment of 1/2in PVC into the middle of the clip.
Tape the strips of paper together, it should be about 15in.
As you wrap the strip of paper around the clip, apply hot glue to keep it held down.
Give it a good paint job.
Now you are done. The strip template is long enough that it leaves a little bit open towards the end so darts can be stored in the magazine.
Additional Photos,
What are your thoughts? If anyone does this mod, feel free to post pictures of it. If you have any questions, feel free to ask.
-A side of nerf
Edited by A side of nerf, 20 July 2008 - 02:37 PM.