- → b1g13en's Content
There have been 72 items by b1g13en (Search limited from 13-June 93)
Thank you for replying. Do you have trouble making small external cuts for like triggers or catch plates?
I have one and use it for all cuts I make pretty much. The only think I have found is that it is not going to perform small internal cuts very well.
On a side note I'll be bringing panthers and longshots for trade. I am looking for a pumpsnaps, berserkers, and settlers of catan.
Yes I am using white foam with green and black felt.
I start school on the 22nd, so depending on how my first week goes, I may or may not show up. If i do show up, this will be my first war!
Also, if anybody lives relatively near Palo Alto and can give me a ride, please PM me.
EDIT: Does anyone use slugs with white foam and green felt? I need to know if I should mark mine.
Have you tried putting the cpvc with blanks in them and heating it in the dryer?
I tried heating some cpvc barrel material with a common coffee warmer instead of metal on a cooktop. I had some (19!) barrels cut to 2 1/2" for an absolver. There's a rubber band holding them together. The warmer is not a particularly powerful one. I tried mine on high and it deformed a few barrels so I would stick to low at first. In usage I found it best to load it with darts (to about 1/4" of the bottom) and then place it on the warmer for 15 - 20 minutes (longer for stock darts). It's hard to gauge but my darts melted a bit at the bottom when they were done. A little less gets a tighter dart but over 25 minutes started to deform the surface of the foam.