How long is the barrel with an 8kg you probably only need like 5 inches maybe a little less. Other than that i would say the breach doesn't seal or the barrel isn't far enough into the breach to seal or gets pushed back.
- → noahback's Content
There have been 11 items by noahback (Search limited from 16-July 93)
Try taking a picture showing how you are trying to assemble the blaster. And then I or some of the other modders may be able to identify your problem. Before you do that look at a picture of the mega cycloneshocks internals and see if you can figure out the problem.
A 3s 1000 mAh lipo is like 15$ 4 imrs can be bought for like 10$ and have 14.8 volts but must draw more than rated current to run stock motors. If you plan on upgrading motors go lipo if you are just going to use stock motors use imrs for cheaper and better gains. If you use imrs in upgraded motors you will destroy them.
Inside flywheels all year long. Outside most strye/flwheel mods only get 140 maybe 150 fps (except fdl which shots about 180, but it costs 300 to 400$ so it is not viable for most) so itcan't compete for range and theyare usually less accurate. Indoors I probably drop 25 bullets around with my imred stryfe (house is not large enough to where lipos would significanly effect play) playing with 2 people with 3 lives each where with a caliburn playing outdoors I could never see using more than 1 mag maybe a round with the same rules at father ranges. Loding mad is just a pian my recomendation for outdoor play sling a stryfe incase some gets close and use an accurate 200-250 fps springer for primary will save lots of mag loading time. (In stock nerf though always flywheels)
thanks i got an imr with a safety circuit and am going to replace the safety circuit, would have gone lipo but with cage fang revamped and batterry it was around 60$. if i does happen to break it I woukd just go lipo by the time i had to rewire.
I have an evader that i ordered imrs and dummies for that i am going to mod but don't know what to do about a few things. First it won't rev unless a mag is in it if i take out the button that the mag presses. If i take the button out but not the circuit will it still rev? Any other small mods i should do to it that only cost a few bucks to nothing.
(ps. I don't want this to become a war on imr vs lipo i looked at a nice lipo setup that was around 60$ but none of my friends mod so having that much power is pointless. Also I know i have to remove thermistor and have the equipment)